Question 1

What SAG setting for the Canyon Sender in DH?

Accepted Answer

Rear SAG: 30-35% of travel (60-70 mm out of 200 mm). Fork: 25-30% (50-60 mm). For coil shock (DHX2 Coil), select spring rate based on rider weight. Find the complete answer on L'Atelier.

Question 2

What bottom bracket for the Canyon Sender?

Accepted Answer

The Sender uses a BSA 83 mm DH threaded BB. Compatible with 157 mm axle DH cranks (Super Boost). Torque: 35-50 Nm. Note: BSA 83 mm is DH-specific, not interchangeable with 73 mm. Find the complete answer on L'Atelier.

Question 3

Canyon Sender pivot torque specs?

Accepted Answer

Sender main pivots: 12-14 Nm. Links: 12 Nm. Shock mount bolts: 8 Nm (top), 14 Nm (bottom). Medium threadlocker (Loctite 243) on all pivots. Find the complete answer on L'Atelier.

Question 4

RockShox Boxxer service on Canyon Sender?

Accepted Answer

Lower leg service every 50 hours: replace dust seals (SKF), 15wt oil in lowers (20cc per side). Full service (Charger): every 200 hours. Bottom bolt torque: 7.4 Nm. Find the complete answer on L'Atelier.

Question 5

What tyre pressure for Canyon Sender in DH?

Accepted Answer

DH starting point for a 75-85 kg rider: front 1.4-1.6 bar, rear 1.6-1.8 bar with DH casing. Tyre insert recommended. Lower by 0.1-0.2 bar on dry, hard-packed terrain. Find the complete answer on L'Atelier.

Question 6

How to bleed SRAM Code brakes on the Sender?

Accepted Answer

Fluid: DOT 5.1 only. Use the SRAM Bleeding Edge kit. Bleed from calliper to lever, syringe pushed upward. Calliper bleed screw torque: 5 Nm. Never use mineral oil in a SRAM system. Find the complete answer on L'Atelier.

Canyon Sender

Especificaciones principales

Valor y precio de mercado

¿Tu modelo no está en la lista?

Todas las especificaciones de la Canyon Sender

Preguntas frecuentes sobre el Canyon Sender

Haz tu pregunta sobre la Canyon Sender